How Can You Replace a Cutlass Bearing?
A cutlass bearing is a bearing on a vessel’s drive shaft log that is commonly made using brass and a lining that is grooved from the inside which is lubricated by the water which enters the grooves during rotation, this.
After some time you must change the cutlass bearing regardless of how often you use your boat. When it is time to change that cutlass bearing, you will find the cutlass bearing a bit far from the keel or somewhere buried in the woodwork of the boat.
Fortunately apart from getting your hands dirty, removing the cutlass bearing is not tricky. These are the steps to follow to replace your boat’s cutlass bearing, now.
Prior to doing anything else, you should first locate the set screws so that you can remove them. In most cases, the screws are found hidden under a thin marine layer of crud and growth. Don’t forget that other boat manufacturers do not use set screws. If you know that set screws are not existing, then it is no use wasting time looking for them.
During a cutlass bearing replacement you will be required to cut the bearing. In the absence of a Sawzall, you can use a hacksaw to cut the cutlass bearing. You should know that you need to have ample experience to be able to use the Sawzall tool from Propeller Depot safely.
Bending the cutlass bearing is the next step. You can bend the cutlass bearing to the inner side using a cold chisel and a hammer so that you reach the other side where you have made a cut. Avoid using a lot of force when hitting the cutlass bearing so that it can bend. If you force it you will damage the strut of the boat.
Put a maple dowel where you have created a space by bending the boat’s cutlass bearing inside and with a hammer slit it opens up to the other end. Do not use metal tools to slit open the cutlass bearing up to its length. The interior of the strut may get damaged by so doing.
Finally, remove the cutlass bearing. Do this with a pair of pliers to hold and remove the bearing. After cleaning the strut’s surface, install a new cutlass bearing. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.
If the ramrod strut is not straight and if it is forced it may get damaged. So that the ramrod of the strut can go in straight use some grease on the cutlass bearing to help it to slide in easily.
Source: click here now